Hello all,
I have a 1997 dmu50v with millplus v320.
Recently I've been getting this S153 (drive not responding) error which requires a cold restart.
It usually happens when I close the door. Once, it happened when I jogged in the z-axis with the door open, but that was with an E130 (Spindle drive: No ready signal).
It never happens during a program, and I've run a few 2 hour ones yesterday and today. The really frustrating part is that a sensor on the ATC went out, so I've been changing tools manually, which requires opening the door of course.
I'm hoping it is the door interlock, and I will replace it being that I have an extra one lying around. What do you guys think it is?
Thanks
Shawn
I have a 1997 dmu50v with millplus v320.
Recently I've been getting this S153 (drive not responding) error which requires a cold restart.
It usually happens when I close the door. Once, it happened when I jogged in the z-axis with the door open, but that was with an E130 (Spindle drive: No ready signal).
It never happens during a program, and I've run a few 2 hour ones yesterday and today. The really frustrating part is that a sensor on the ATC went out, so I've been changing tools manually, which requires opening the door of course.
I'm hoping it is the door interlock, and I will replace it being that I have an extra one lying around. What do you guys think it is?
Thanks
Shawn